|
| |
Flip up / Swing up Safety Rail |
 |
 |
|
|
|
|
 |
| |
Specifications: |
| |
Site Location: The horizontal support is intended for use with
the code 1055 swing up grab bar to allow for floor mounting where
adequate in wall backing is unavailable.
Materials: Carrier stand shall be 1-1/2" x 3" x 1/8” thick crs
tubing. Floor mounting plate shall be 3/8" crs plate. All
welded construction.
Installation: Secure to floor with
appropriate anchoring system for floor material. Use floor plate as a
template to locate mounting holes. Drill holes and set anchors as
required. Anchor bolts should be 3/8" diameter, with a minimum pull out
strength of 3,500 lbs. Medium duty sleeve anchors typically have a 5,300
lb. pullout rating and heavy duty wedge anchors can offer up to 5,900 lbs. Mount
carrier stand to anchors and secure swing up grab bar to
vertical support. We suggest installation by a qualified tradesman.
Grab Bar Mounting: Requires four 1/4"-20 unc machine screws to secure Frost Code 1055 grab
bar to vertical support. For regular mounting a minimum machine screw
length of 7/8" is required. When mounting "in wall" the
machine screw length will vary due to the thickness of wall materials
and other decorative surfaces. The correct machine screw length should
be determined by the contractor or designer of the installation.
Mounting screws are not included.
In wall Installation: Threaded
inserts on vertical
support allow for blind fastening of flip up grab bar during in wall
installation. We recommend a spacer tube to be used for in wall drywall
installation. |
|
|
Description and specifications applicable on
date issued. Frost reserves the right to make improvements or
changes without
notice. |
|
Quality 
